If a piece of equipment needs a seal before it runs, it falls somewhere on this list. Every service below is delivered anywhere in Ontario, from Windsor through the Golden Horseshoe to Ottawa and the north.
Trigger determination, site inspection, standards gap analysis and a sealed report with a deficiency list your team can close out.
Task based risk assessment and guard design for presses, conveyors, robots and CNC. We specify the protective measure, then verify the safety function achieves the required Performance Level.
Full DHA under the consolidated combustible dust standard. Material characterisation, compartment by compartment hazard identification, and a ranked mitigation plan you can budget against.
Collector siting, deflagration venting, isolation and suppression reviewed against the standard, with the calculation package your insurer and AHJ keep asking for.
Field proof load testing on the anchorage that holds your racking, guarding, mezzanines and equipment down, with a sealed report of measured loads and displacements.
Panel design and build, safety relay and safety PLC architecture, and verification that the installed circuit does what the drawing says it does.
Independent commissioning attendance and functional testing, plus balancing verification on ventilation and dust extraction systems.
Code review where a process touches fire and life safety: flammable liquid storage, spray application, industrial ovens and hot work.
Send drawings or photographs and we will tell you plainly whether a review is required, before any fee is discussed. We work across all of Ontario.
For anything specific to your equipment, call 613-983-2642.